F210 Donut Loadcell
Standard Ranges 7.5, 10, 15, 25 and 50kN (750kgf to 5tonnef)
- Hardened stainless steel body
- Very high structural load limit
- Standard 1 year warranty
- Tensile applications are â€˜fail-safeâ€™
- Sealed to IP65
- Traceable calibration with certificate included in the standard price
Non-linearity - Terminal
Creep - 20 minutes
Rated output - Nominal
Rated output - Rationalised
Zero load output
Temperature effect on rated output per Â°C
Temperature effect on zero load output per Â°C
Temperature range - Compensated
-10 to +50
Temperature range - Safe
-10 to +80
Excitation voltage - Recommended
Excitation voltage - Maximum
Insulation resistance - Minimum at 50Vdc
Overload - Safe
Overload - Ultimate
Weight - Nominal (excluding cable)
240 to 280
All standard ranges have a stainless steel body and a painted steel case.
F210 Donut Loadcell. Geometry: Axial strain cylinder in a sealed case, with raised end load bearing faces and hole right through. For use in compression or in fail-safe tensile applications.
The F210 is ideally suited to engineering force measurements including through centre safety testing of cables, rods and bolts.
It is designed for easy installation, usually between two flat faces bearing on its loading rings, either unattached or with retaining spigots positioned in the centre hole. Alternatively tensile load transfer can be achieved via a tie rod assembly through the centre hole. In this way the loadcell can indirectly measure tensile loads in a "fail-safe" mode.
We are happy to design variants of this loadcell to meet your specific requirements. Versions can be manufactured for fully compensated operation up to +250°C. Please consult our engineering department.
Compression, IP65, unrationalised
Compression, IP65, rationalised
Structural Stiffness - Nominal
5.0 x 108
6.7 x 108
1.0 x 109
1.7 x 109
3.3 x 109
- AL = Applied load.
- RL = Rated load.
- Temperature coefficients apply over the compensated range.
- The load must be applied directly through the central loading axis.
The loadcell is fitted with 2 metres of PVC insulated 4 core screened cable type 7-2-4C.
Excitation + = Red, Excitation - = Blue, Signal + = Yellow, Signal - = Green, Screen = Orange.
The screen is not connected to the loadcell body.